Models > GGG390LXB02

GGG390LXB02 Whirlpool Range - Overview

Get Parts and Repair Help for GGG390LXB02

If you know the range repair part you need, you can browse the list of all parts on the GGG390LXB02, or you can search by name or part description. You can also find your part by where it is located on the GGG390LXB02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GGG390LXB02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.76

Levelling Leg

This leg is sold individually.

$36.04

Oven Rack

Sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$52.75

Bake Igniter

This part ignites to help bake your food.

$2.70

Screw

This screw is sold individually.

$5.25

Touch-Up Paint - White

$18.07

2 Piece Broiler Pan

$43.07

Broiler Pan with Roasting Rack

$2.70

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor was bad on upper oven

  • Customer: David from Temple Terrace FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 27 of 31 people found this instruction helpful
First I removed the lower tray and all parts covering the ignitor on the upper oven. 2. Then I removed the screws holding down the ignitor and flame distributor. 3. I then had to pull out the oven from the wall and remove the back panel to expose the wires connecting the ignitor. This required the removal of about six screws but they were fairly easy to ... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more

Oven would not heat

  • Customer: Timothy from Elkhorn WI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 14 of 16 people found this instruction helpful
Lifted door off hinges; removed lower oven spill plate; unmounted bake igniter from heat shield; pulled stove away from wall; removed rear access panels (4 screws); unplugged bake igniter; installed new part; vacuumed behind stove and mopped floor (this took more time than installing the part); oven is back in cookie baking mode! read more