Models > GGG388LXB00

GGG388LXB00 Whirlpool Range - Overview

Get Parts and Repair Help for GGG388LXB00

If you know the range repair part you need, you can browse the list of all parts on the GGG388LXB00, or you can search by name or part description. You can also find your part by where it is located on the GGG388LXB00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GGG388LXB00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?


This screw is sold individually.


Levelling Leg

This leg is sold individually.


Oven Rack

Sold individually.


Bake Igniter

This part ignites to help bake your food.



This screw is sold individually.



This screw is sold individually.


Igniter Screw

This screw is sold individually.


2 Piece Broiler Pan


Touch-Up Paint - White



Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor was bad on upper oven

  • Customer: David from Temple Terrace FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 22 of 23 people found this instruction helpful
First I removed the lower tray and all parts covering the ignitor on the upper oven. 2. Then I removed the screws holding down the ignitor and flame distributor. 3. I then had to pull out the oven from the wall and remove the back panel to expose the wires connecting the ignitor. This required the removal of about six screws but they were fairly easy to ... read more

Oven would not heat

  • Customer: Timothy from Elkhorn WI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 13 people found this instruction helpful
Lifted door off hinges; removed lower oven spill plate; unmounted bake igniter from heat shield; pulled stove away from wall; removed rear access panels (4 screws); unplugged bake igniter; installed new part; vacuumed behind stove and mopped floor (this took more time than installing the part); oven is back in cookie baking mode! read more

Scratches in Surface

  • Customer: Michelle from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 7 of 9 people found this instruction helpful
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great. read more