Models > GFS185/MN04

GFS185/MN04 Caloric Refrigerator - Overview

Get Parts and Repair Help for GFS185/MN04

If you know the refrigerator repair part you need, you can browse the list of all parts on the GFS185/MN04, or you can search by name or part description. You can also find your part by where it is located on the GFS185/MN04 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GFS185/MN04 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$25.16

Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.

THERMOSTAT,LOW LIMIT

DRAIN CUP

$309.64

COMPRESSOR

GUIDE, QUICK REF. - MAYTAG

POST, CRISPER

SCREW

SUPPORT, CRISPER

DOOR GASKET

PANEL,CONTROL-COMMERCI

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

GAS FLAME WOULD DROP OUT

  • Customer: FRED from BRIELLE NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 38 of 52 people found this instruction helpful
first it was a process of alimination to find out why it was dropping out. after the problem was found it was just a matter of replacing the holding coil on the gas valve.
THANK YOU
FRED KENNEY SR read more

Dryer would not heat up.

  • Customer: Roger from Bonners Ferry ID
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 18 people found this instruction helpful
I unplugged the dryer,removed the two small screws on the front of the dryer and pulled the bottom forward. The two wires connected to the door do not have to be removed. With an electrical tester using the Ohm setting I tested the Radiant sensor and the Gas Valve coils. The two terminal coil was DOA. The dryer can be operated with the front open as long as... read more

Dyer would not heat, flame would shut off within 10 seconds

  • Customer: Christy from Riley MI
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 16 of 20 people found this instruction helpful
I opened the panel, undid the plugs, detached the radiant sensor by undoing one screw and removed and replaced the part. Fairly simply. read more