Models > GFS142/MN00

GFS142/MN00 Caloric Refrigerator - Overview

Get Parts and Repair Help for GFS142/MN00

If you know the refrigerator repair part you need, you can browse the list of all parts on the GFS142/MN00, or you can search by name or part description. You can also find your part by where it is located on the GFS142/MN00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.86

Evaporator Fan Motor Kit

This kit comes with two mounting grommets, two sleeves (not to be used on porcelain models), two #8 mounting screws, and a push-on fan blade.

$3.54

SCREW

THERMOSTAT,LOW LIMIT

DRAIN CUP

$309.64

COMPRESSOR

SCREW

ASSY,REAR BULKHEAD

HEAT EXCHANGER

PANEL, INNER DOOR, FR

TRANSFORMER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Unit very noisy and freezer too warm

  • Customer: Michael from Churchville NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 37 of 40 people found this instruction helpful
First I removed the racks in the freezer. The rack supports on the sides lift off without tools. The evaporator cover is at the back of the freezer. 4 phillips head screws. The cover lifts up then forward to expose the evaporator, evaporator fan and duct. The duct is held by 3 hex head screws. The evaporator fan is attached to the duct with a wiring pigtail ... read more

Evaporator Fan had quit running

  • Customer: Duane from Piper City IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 11 of 12 people found this instruction helpful
After unplugging the fridge, I removed all the phillips head screws from the evaporator fan housing as well as the back cover and the bottom of the freezer compartment (7) in all. After first removing the bottom cover - then the back cover I could access the evaporator fan unit. This was held in place with two hex-head screws that were easily removed with a... read more

freezer making a squealing sound

  • Customer: PAUL from Boiling Springs SC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 11 of 12 people found this instruction helpful
First I Removed the racks. Next 3 hex bolts that secured the ice maker. Undid the ponytail wiring. 3 Phillips screws to remove the metal back. unplugged the Evaporator Fan Motor. Replaced the new one. reassembled. read more