Models > GFC240-01

GFC240-01 Hotpoint Food Waste Disposer - Overview

Get Parts and Repair Help for GFC240-01

If you know the food waste disposer repair part you need, you can browse the list of all parts on the GFC240-01, or you can search by name or part description. You can also find your part by where it is located on the GFC240-01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your food waste disposer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the GFC240-01 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.79

Splash Guard

This is a flexible rubber cover that is over the top of the sink drain. It keeps liquids and smaller food particles from splashing back into the sink.

Order within the next 3 hrs and your part ships today!
$3.62

STOPPER

This is a flexible rubber cover that fits over the top of the sink drain. It opens up in the middle and will allow you to feed water or food items into a garbage disposal while keeping liquids and smaller food particles from splashing back into the sink.

Order within the next 3 hrs and your part ships today!
$8.32

Flange Gasket - Fiber

Sold individually.

Order within the next 3 hrs and your part ships today!
$2.79

FLANGE GASKET

Order within the next 3 hrs and your part ships today!
$10.46

CUSHION MOUNTING RING

Order within the next 3 hrs and your part ships today!
$22.62

MOUNTING RING

Order within the next 3 hrs and your part ships today!
$22.62

SINK FLANGE

Order within the next 3 hrs and your part ships today!
$4.48

SUPPORT RING

Order within the next 3 hrs and your part ships today!
$1.65

SCREW

Order within the next 3 hrs and your part ships today!

OUTLET ELBOW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Deteriating splash guard

  • Customer: Brian from North Charleston SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 35 of 36 people found this instruction helpful
The splash guard for the disposer was deteriorating and kept falling into the disposer and getting chewed up making it even less reliable. I purchased two different 'universal' splash guards at the hardware store. Neither of them fit. I finally crawled under the sink with my eyeglasses and a flash light to find the model number. I searched for the model... read more

Splash guard was worn out

  • Customer: Phyllis from Avon MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 6 of 7 people found this instruction helpful
Purchased new one and just put into the hole. read more

Leaky GE Disposall

  • Customer: Donald from Tampa FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 7 of 12 people found this instruction helpful
Mount Ring was very difficult to remove. Hammer needed to unlock. Once removed, rubber and fiber gaskets were easily replaced. Cushion Mount did not attach properly to sink flange after many attempts, so Mount Ring was placed too high for hopper to attach. The cushion mount was finally placed on flange correctly (not sure why it attached incorrectly previous... read more