Models
>
GFB762F-00
GFB762F-00 General Electric Food Waste Disposer - Overview
Sections of the GFB762F-00
[Viewing 1 of 1]Keep searches simple, eg. "belt" or "pump".
Sink Flange
PartSelect #: PS12722852
Manufacturer #: WC15X20161
The sink flange attaches to your sink drain opening and provides a connection to mount the disposal unit to the sink itself. If your food waste disposer is leaking, there are a few places that you sho...
$39.58
In Stock
Rubber Flange Gasket
PartSelect #: PS7320281
Manufacturer #: WC03X10007
This is a flange gasket for a food waste disposer or garbage disposer. The gasket provides a seal between the sink opening and disposal flange. You may need to replace this gasket if your appliance is...
$8.10
In Stock
Flange Gasket - Fiber
PartSelect #: PS6883604
Manufacturer #: WC03X10008
This item is sold individually. The fiber sink flange gasket works with your food waste disposer. This part creates a seal that prevents any water from leaking. It is positioned between the sink flang...
$17.43
In Stock
SUPPORT RING
PartSelect #: PS7783352
Manufacturer #: WC05X10002
This support ring, also known as mounting ring, is a genuine OEM replacement part for use in food waste disposers. It is a circular plastic piece with an outer diameter of 4.75 inches. It is found ins...
$11.30
In Stock
Disposal Stopper
PartSelect #: PS8746187
Manufacturer #: WC11X10005
This stopper is designed for use with garbage disposals. If your disposal will not start, will not run properly, or is starting to smell bad, repairing it could be as simple as replacing the stopper. ...
No Longer Available
Questions And Answers for GFB762F-00
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the GFB762F-00
[Viewing 1 of 1]Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Leaky GE Disposall
Mount Ring was very difficult to remove. Hammer needed to unlock. Once removed, rubber and fiber gaskets were easily replaced. Cushion Mount did not attach properly to sink flange after many attempts, so Mount Ring was placed too high for hopper to attach. The cushion mount was finally placed on flange correctly (not sure why it attached
... Read more
incorrectly previously) but all is well with no leaks. Dishwasher hose needed to be re-attached after hopper mounted and locked in position.
Read less
Parts Used:
-
Donald from Tampa, FL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers
10 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!