Models > GDT226SGL1WW > Instructions

GDT226SGL1WW General Electric Dishwasher - Instructions

All Instructions for the GDT226SGL1WW
1 - 2 of 2
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
While the dishwasher door was fully open, someone accidentally turned and tripped over it with much of their weight. Now the door won't fully close.
*UNPLUG THE DISHWASHER
*remove 2 mounting screws attatching dishwasher to underside of countertop.
*with the dishwasher door closed, remove left and right side hinge cables off pulley and hinge.
*fully open door and remove all perimeter screws except for 2 screws holding the latch assembly.
*carefully separate outer door shell from door body.
*disconnect electrical clip from inside top of outer shell. Carefully set outer shell aside.
*each hinge has 2 Torx head screws and 2 Phillips head screws, remove these. You can now slide the door body out and away from the hinges and dishwasher.
*these hinges were slightly bent so I had to use a ball peen hammer to tap them off the post.
To reassemble, reverse these instructions.
Parts Used:
HINGE MECHANISM RH HINGE MECHANISM LH
  • Al from REDDING, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper basket sprayer was falling off under pressure.
Replaced the sprayer with new. Very easy repair.
Parts Used:
MID SPRAY ARM CONDUIT ASSEMBLY
  • Richard from SEELEY LAKE, MT
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GDT226SGL1WW
1 - 2 of 2
Back to Top