Models > GD5RVAXVY02

GD5RVAXVY02 Whirlpool Refrigerator - Overview

Get Parts and Repair Help for GD5RVAXVY02

If you know the refrigerator repair part you need, you can browse the list of all parts on the GD5RVAXVY02, or you can search by name or part description. You can also find your part by where it is located on the GD5RVAXVY02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GD5RVAXVY02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$54.43

Water Filter

This Whirlpool filter reduces taste and odor of clorine, small particulates, benzene, toxaphene, lead and mercury. It pushes in the botton front grille. Suggested replacement is ev...

$3.76

Lower Door Closing Cam

This door closing cam is located on the bottom of the fridge/freezer.

$2.52

Light Bulb - 40W

Sold individually.

$114.64

Ice Maker Assembly - 8 Cube

This icemaker can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. Reuse bottom bracket from the original icemaker and attach to the new.

$13.89

Pan Slide Track

This part can be used for either the left or right side of the pan.

$3.82

Door Cam

Note: As per manufacture a new screw is needed to mount door cam. Sold individually.

$143.96

Electronic Control Boards - Emitter and Receiver

This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also te...

$71.06

Water Inlet Valve

The water inlet valve is a solenoid-operated switch that, when activated, releases water from the supply line to the water valve and into the compact icemaker mold. Note: This valve has been updated by the manufacturer and NO longer includes the removable pre-filter bracket connector. Must be ordered separately on PS3502196

$8.07

Ice Guide

This ice guide is located in the freezer door.

$49.60

Ice Door Kit

This kit includes the ice door, support, spring and delay. The heater ribbon is no longer attached - the heater is no longer needed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced Two Broken Tracks

  • Customer: Steve from Milton GA
  • Difficulty: Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 475 of 474 people found this instruction helpful
The old tracks had been falling out consistently, causing the deli tray to fall on top of the food below it (which included the eggs, though none were broken since they were in a hard plastic container).

I had some difficulty getting the new track installed, however. All the parts lined up, but I just couldn't get the tracks to slide into place. ... read more

there were directions

  • Customer: Kate from Jacksonville FL
  • Difficulty: Very Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required:
  • 536 of 955 people found this instruction helpful
We didn't know where the product went and it was very difficult to install. read more

Ice maker stopped functioning

  • Customer: Phil from Auberry CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 252 of 263 people found this instruction helpful
Remove the icemaker service door... gently pry the door pins from the hinge sockets. Remove the 3 screws from the under side of the icemaker with a nut driver (1/4"). Gently remove the icemaker . It's a tight fit between the top of the compartment and the icemaker lower support tray. Next, disconnect the electrical connector at the right side. You're do... read more