Models > GCRG400

GCRG400 Maytag Range - Overview

Get Parts and Repair Help for GCRG400

If you know the range repair part you need, you can browse the list of all parts on the GCRG400, or you can search by name or part description. You can also find your part by where it is located on the GCRG400 by selecting a section below. We’ve also included any installation videos we have for GCRG400 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

The top of this part is now black.

$2.88

Frame Screw

Sold Individually.

$2.73

Screw - 6-32 x 5/16

Sold individually.

$7.96

Light Bulb Socket

This light bulb socket is located inside the oven cavity.

$5.50

Door Handle Spacer Kit

This door handle spacer assembly contains two screws and two spacers.

$12.17

Clock Knob

Sold individually.

$19.58

Anti-Tip Screw

Sold individually.

$144.16

Oven Safety Valve

Once this valve senses the desired heat, this part will open up and allow the gas to travel to the oven burner.

$5.97

BOLT- T'ST

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

pilot lit but oven would light

  • Customer: Paul from Arlington MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 11 of 15 people found this instruction helpful
replaced the oven safety valve. This device uses heat from the pilot to hold open a valve that allows gas from the thermostat control to feed the main burner. It works by boiling the liquid mercury in the sensor bulb, producing the pressure to hold open the valve. My sensor had failed from old age, leaking the mercury.

Spilled mercury needed to... read more

Replacing the bulb in the freezer side

  • Customer: Yafa (and David) from Bothell WA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 5 of 7 people found this instruction helpful
Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.

Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas. read more

light bulb went out in my oven

  • Customer: Janet from Ada MI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 4 people found this instruction helpful
My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on. read more