Models > GCG1200S4BW

GCG1200S4BW General Electric Trash Compactor - Overview

Get Parts and Repair Help for GCG1200S4BW

If you know the trash compactor repair part you need, you can browse the list of all parts on the GCG1200S4BW, or you can search by name or part description. You can also find your part by where it is located on the GCG1200S4BW by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the GCG1200S4BW [Viewing 4 of 4]

$89.27

Compactor Bags - Package of 12

These bags will fit all fifteen inch rectangular trash compactors.

$77.09

Drive Gear Kit

$107.56

Rotary Switch Kit

$85.43

Foot Pedal - Black

$49.25

Power Nut Kit

This kit includes the power nut and 2 clips/washers. Screws/studs are sold separately.

$28.31

Rotary Knob

$474.75

Motor and Switch Assembly

$77.76

PANEL FRONT WH/BK

$45.93

SWITCH DRAWER TILT

$22.62

SLIDE RAM

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

trash compactor ram not moving - broken plastic drive gear

  • Customer: william from andover MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 4 of 7 people found this instruction helpful
1) pulled the compactor from under the counter and unplugged it. 2) tipped it on its side 3) removed 5 screws (3 on the motor side and two on the bottom) an took off the bottom cover plate. 3) using the pliers i pulled of the retainer clip from the large drive gear(it had broken on only the hub remain attached) 4) i then just slid in the new gear, snapped in... read more

One of the nuts on the ram stripped out

  • Customer: kelton from weatherford TX
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Socket set
  • 0 of 1 people found this instruction helpful
1)Pulled the unit out remove the top and bottom covers. 2)Disconnected the drive chain by removing the sproket from the motor. 3)Unscrewed the drive rod on the side that worked and removed the ram. 4)Reassembled and used the bin for trash while waiting for the part. 5)The nut came with clips included (this was not noted in the order but is vital) removed the... read more

dent in front panel

  • Customer: James from Porter Ranch CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Really easy. Two screws on the back side. Loosen them and pull the top off. Panel slides right out from the top. read more