Models > GC932EXV8

GC932EXV8 Frigidaire Microwave - Overview

Get Parts and Repair Help for GC932EXV8

If you know the microwave repair part you need, you can browse the list of all parts on the GC932EXV8, or you can search by name or part description. You can also find your part by where it is located on the GC932EXV8 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for GC932EXV8 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.55

Drip Pan

This round chrome drip pan contains a center hole of approximately four inches wide.

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$39.80

Spark Module - 120V

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$44.29

Door Hinge - Right Side

$29.90

Long Ceramic Igniter Assembly

$44.80

Door Hinge - Left Side

$25.30

Clock Knob

Sold Individually.

$6.93

SCREW-LEVELING

$1.18

SCREW #10A X 1/2

$31.02

Gas Spark Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner

Common Symptoms of the GC932EXV8 [Viewing 1 of 25]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My burners would not light. There wasn't the tell tale "click, click, click" of the spark module.

  • Customer: Jonathan from Arkport NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 11 of 16 people found this instruction helpful
First I had to slide the stove out of its cubby and then I removed the two screws holding on the shield. I next removed the wires going to the spark module. I removed the top screw and loosened the bottom one. Installed the new spark module in reverse order. Less than 15 minutes for whole repair. Still have problems with spark module not working if oven... read more

Two top burners would not light, defective switch

  • Customer: Donald from Middle Village NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
Warning- we found a lot of bare wires in this stove, check your wires before replacing the bad switches. I lifted the top, disconnected the power, pulled off the knobs, unscrewed the switch for the back light, removed seven screws to finally get the front panel off. Once you have the front panel off, changing the swich takes less than a minute. The switches ... read more

original drip pans were rusting on the undersides

  • Customer: Sandra from Okeene OK
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 8 of 9 people found this instruction helpful
Just to point out the pans were delivered within a few days which was very quick. I just dropped them in. They fit perfect. Thank You for no stress. read more