Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GC3111SXAW

GC3111SXAW Maytag Range - Overview

Get Parts and Repair Help for GC3111SXAW

If you know the range repair part you need, you can browse the list of all parts on the GC3111SXAW, or you can search by name or part description. You can also find your part by where it is located on the GC3111SXAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GC3111SXAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.50

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$49.74

Burner Head Cap with Spark Electrode

This is a black burner head with the spark electrode. NOTE: This part has been updated and there is no longer a gasket seal required.

$6.49

Levelling Leg

This levelling leg is just under three inches long. It is all black in color and is made entirely of plastic.

$2.61

Screw

This screw is sold individually.

$46.78

Oven Rack

Used in the lower oven. Sold individually.

$40.09

SEAL- DOOR

This door seal is fifty-three inches long. It is all black in color and is made of rubber. There are metallic clips sticking out of this seal at various points. These clips help to secure the seal to range doors.

$2.91

Screw (4)

Sold Individually.

$34.16

Double Drip Pan

Sold individually.

$4.88

Screw

Sold individually.

$8.65

Light Bulb Socket

This light bulb socket is located inside the oven cavity.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence, RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 108 of 122 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

Burner wouldn't start

  • Customer: Yury from Brooklyn, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 32 of 45 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

worn out door seal

  • Customer: Stella from Charlotte, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 23 of 24 people found this instruction helpful
removed old clips and remaining parts of old seal...new part already had clips attached, so just snapped them into holes in oven door. read more