Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GC2227EED1

GC2227EED1 Maytag Refrigerator - Overview

Get Parts and Repair Help for GC2227EED1

If you know the refrigerator repair part you need, you can browse the list of all parts on the GC2227EED1, or you can search by name or part description. You can also find your part by where it is located on the GC2227EED1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GC2227EED1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$23.23

Light Switch

This part turns on the light when the door is opened.

$25.56

BLADE-FAN

The fan blade is used to blow air over the condenser.

$7.40

Natural Door Closer

$17.22

Ice and Water Dispenser Actuator Pad

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

$6.33

Ice Chute Door Return Spring

Sold Individually.

$23.44

Dispenser Grill

This grill sits at the bottom of the water/ice dispenser.

$9.21

Door Basket Stop - Left Side

$9.21

Door Basket Stop - Right Side

$88.39

Chill Department Door

$4.63

Screw

This screw is sold individually

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 90 of 106 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Refrigerator Filter needed replacing

  • Customer: Bruce from Alfred Station, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 81 of 91 people found this instruction helpful
Turn counter clockwise, following the remove arrow on the filter, until it stops. Wiggle and pull down on the filter until it comes off. Put date sticker on new filter to remember when it was replaced. Align the lines on the filter and push it up where the old one was and turn it clockwise until it stops, following the install arrow. Close the door and p... read more

No ice in ice trey

  • Customer: Wayne from Leesburg, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 70 of 81 people found this instruction helpful
The easiest thing to do was pull the ice make off. After taking the 3 screws out of the wall of the freezer, take a screwdriver (flathead) and push on the tab for the electrical plug and wiggle the cord out. Then you can take 3 screws out for the main cover and another 2 screws on the next cover. There's the part, pop it out and replace holding pins and star... read more