Models > GA3510PRW

GA3510PRW Maytag Range - Overview

Get Parts and Repair Help for GA3510PRW

If you know the range repair part you need, you can browse the list of all parts on the GA3510PRW, or you can search by name or part description. You can also find your part by where it is located on the GA3510PRW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GA3510PRW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.71

Drip Bowl - 6"

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.

$3.96

Drip Bowl - 6"

$27.92

Bake Element

This oven bake element with push-on terminals has a terminal depth of three inches. It is found on the bottom of the oven.

$10.15

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$3.76

Levelling Leg

This leg is sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

$30.71

Door Seal

This oven door seal prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.

$40.60

Element Infinite Switch - 8"

This is the left front element switch.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned in half

  • Customer: mike from gold bar WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 476 of 475 people found this instruction helpful
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you. read more

No heat - element had burst.

  • Customer: John from Marion IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 227 of 291 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 98 of 107 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more