Quick Question!

Have you ever purchased from PartSelect.com before?

Models > G3868XRW

G3868XRW Maytag Range - Overview

Get Parts and Repair Help for G3868XRW

If you know the range repair part you need, you can browse the list of all parts on the G3868XRW, or you can search by name or part description. You can also find your part by where it is located on the G3868XRW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for G3868XRW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the G3868XRW

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$23.99

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$19.22

Broiler Drawer Support - Front

$69.92

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$41.10

Door Hinge Kit

This oven door hinge assembly comes with two screws and is intended for use with many ovens. It can be used on either the left or right hand side.

$4.47

Screw

This screw is sold individually.

$68.78

Door Handle

Handle only.

$4.89

SCREW

Latch Lever Clip

$5.63

SCREW

Rubber Door Spacer

Sold Individually. This spacer has adhesive on one side. This spacer is used between door panels of ranges and ovens.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned in half

  • Customer: mike from gold bar, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 522 of 522 people found this instruction helpful
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you. read more

No heat - element had burst.

  • Customer: John from Marion, IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 231 of 295 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham, AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 120 of 129 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more