Models > FWTR425RHS0

FWTR425RHS0 Frigidaire Washer - Overview

Get Parts and Repair Help for FWTR425RHS0

If you know the washer repair part you need, you can browse the list of all parts on the FWTR425RHS0, or you can search by name or part description. You can also find your part by where it is located on the FWTR425RHS0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FWTR425RHS0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$42.77

Shock Absorber Kit

This kit is used for front load washers and includes 2 dual-stage shock absorbers, 1 spare shock mounting pin and 4 locking nuts. These shock absorbers keep the washer from vigorou...

$84.22

Drain Pump - 60Hz 120V

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$26.68

Single Spring with Insulators

$5.27

SCREW

$24.30

Drive Belt - 6 ribs

$43.41

Tub-To-Pump Hose

$66.84

Bellow with Clamp

Also known as the door boot seal. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the do...

$24.04

Drum Vane

Also known as a Drum Baffle. Sold individually.

$25.38

Single Shock Mounting Pin

$29.18

Dispenser Drawer

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Drum making loud noise

  • Customer: Scott from Riverview FL
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 91 of 107 people found this instruction helpful
Turned out drum brackets were corroded, so drum and shell-rear/brg and gasket needed replacing

1. Disconnect power and water lines
2. Remove rear and top panels
3. Remove control knobs, Assembly, soap dispenser, and Assembly cons frame/trim
4. Remove all screws from control panel mounting bracket (panel-cont mtg wing bend), disc... read more

Both vibration shock absorbers broken

  • Customer: Douglas from Medical Lake WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 63 of 70 people found this instruction helpful
removed 2 screws and removed top access cover. removed 2 screws and removed front access cover. removed 4 retaining pins (one with nammer and punch because it was stuck) connected lower ends of new shocks with plastic pins, extended each shock to slip fit and connected upper ends to wash tub mounts. Reinstalled panels. I wish I could say that it all went w... read more

drain pump motor had seized as result of foreign objects

  • Customer: Charles from Raleigh NC
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 49 of 52 people found this instruction helpful
After turning off water, disconnecting power, and sucking water out of the tub and drain hose with a shop vac, I removed the front kick panel (took out two sheet metal screws). Then I removed two mounting screws from the pump assembly, and disconnected two hose clamps (inlet and outlet hoses) with a pair of pliers. Very simple, very easy. The pain in the fa... read more