Models > FWT449GFS1

FWT449GFS1 Frigidaire Washer - Overview

Get Parts and Repair Help for FWT449GFS1

If you know the washer repair part you need, you can browse the list of all parts on the FWT449GFS1, or you can search by name or part description. You can also find your part by where it is located on the FWT449GFS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FWT449GFS1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$68.60

Door Lock and Switch Assembly

***NOTE: As per the manufacture, some models require a new wire harness and a door strike for this door lock assembly to work on the appliance. The original style lock would requir...

$45.43

Shock Absorber Kit

This kit is used for front load washers and includes 2 dual-stage shock absorbers, 1 spare shock mounting pin and 4 locking nuts. These shock absorbers keep the washer from vigorous shaking during it's cycles.

$18.46

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$12.45

Door Catch

This washer door catch is a replacement from the original. This is only available in black.

$84.22

Drain Pump - 60Hz 120V

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$26.68

Single Spring with Insulators

$5.27

SCREW

$20.89

Drain Hose

This part comes with a ninety degree elbow.

$23.39

Timer Knob Assembly

$26.88

Drive Belt - 6 ribs

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The door catch broke and the door would not close.

  • Customer: Maryann from Sandy Hook CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 460 of 462 people found this instruction helpful
First, I had to remove 2 screws to take off the 2 broken pieces of the door catch. Then I put the new one on using the same 2 screws. The door is now able to close, but does not lock properly. In order to make it work, I put a thin piece of rubber into the place where the door meets the machine. This causes the lock to engage and the machine to work. I ... read more

Door on washer wouldn't lock or start

  • Customer: DOUG from KING FERRY NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 189 of 225 people found this instruction helpful
1. Unplug unit.
2. Unscrew 2 nuts holding top in place in rear of unit using phillips head screwdriver.
3.Slide top back and remove.
4. Open door of washer and unscrew 2 screws holding in door lock unit.
5.Pull out unit from the top and install new unit reconnecting the 3 wire connections. read more

Drum making loud noise

  • Customer: Scott from Riverview FL
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 89 of 105 people found this instruction helpful
Turned out drum brackets were corroded, so drum and shell-rear/brg and gasket needed replacing

1. Disconnect power and water lines
2. Remove rear and top panels
3. Remove control knobs, Assembly, soap dispenser, and Assembly cons frame/trim
4. Remove all screws from control panel mounting bracket (panel-cont mtg wing bend), disc... read more