Models > FWT445GES0

FWT445GES0 Frigidaire Washer - Overview

Get Parts and Repair Help for FWT445GES0

If you know the washer repair part you need, you can browse the list of all parts on the FWT445GES0, or you can search by name or part description. You can also find your part by where it is located on the FWT445GES0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FWT445GES0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FWT445GES0 [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Door Lock and Switch Assembly

NOTE: As per the manufacture, some models require a new wire harness and a door strike for this door lock assembly to work on the appliance. The original style lock would require t...


Shock Absorber Kit

This kit is used for front load washers and includes 2 dual-stage shock absorbers, 1 spare shock mounting pin and 4 locking nuts. These shock absorbers keep the washer from vigorous shaking during it's cycles.


Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.


Door Catch

This washer door catch is a replacement from the original. This is only available in black.


Single Spring with Insulators




Drain Hose

This part comes with a ninety degree elbow.


Remote Style Pump with Motor

Use this with either a top load or front load washer. This pump has an horizontal mount.


Drive Belt - 6 ribs


Tub-To-Pump Hose

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The door catch broke and the door would not close.

  • Customer: Maryann from Sandy Hook CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 471 of 474 people found this instruction helpful
First, I had to remove 2 screws to take off the 2 broken pieces of the door catch. Then I put the new one on using the same 2 screws. The door is now able to close, but does not lock properly. In order to make it work, I put a thin piece of rubber into the place where the door meets the machine. This causes the lock to engage and the machine to work. I ... read more

Door on washer wouldn't lock or start

  • Customer: DOUG from KING FERRY NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 273 of 321 people found this instruction helpful
1. Unplug unit.
2. Unscrew 2 nuts holding top in place in rear of unit using phillips head screwdriver.
3.Slide top back and remove.
4. Open door of washer and unscrew 2 screws holding in door lock unit.
5.Pull out unit from the top and install new unit reconnecting the 3 wire connections. read more

Both vibration shock absorbers broken

  • Customer: Douglas from Medical Lake WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 95 of 102 people found this instruction helpful
removed 2 screws and removed top access cover. removed 2 screws and removed front access cover. removed 4 retaining pins (one with nammer and punch because it was stuck) connected lower ends of new shocks with plastic pins, extended each shock to slip fit and connected upper ends to wash tub mounts. Reinstalled panels. I wish I could say that it all went w... read more