Models > FWS235RBS3

FWS235RBS3 Frigidaire Washer - Overview

Get Parts and Repair Help for FWS235RBS3

If you know the washer repair part you need, you can browse the list of all parts on the FWS235RBS3, or you can search by name or part description. You can also find your part by where it is located on the FWS235RBS3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FWS235RBS3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$12.46

Drive V-Belt

This belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$17.91

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$33.09

Washer Lid Lock with External Safety Switch

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

$5.27

SCREW

$9.60

Tension Idler Pulley

This idler arm assembly comes with the pulley wheel.

$4.45

Leveling Leg

$61.18

Remote Style Pump with Motor

Use this with either a top load or front load washer. This pump has an horizontal mount.

$46.50

Tub Seal Assembly

This seal helps prevent any leaking around the transmission of washing machines.

$23.57

Selector Knob

This white knob accepts a D-shaped shaft.

$17.08

Drain Hose

This part comes with a ninety degree elbow.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The primary problem was that the tub seal assembly was leaking.

  • Customer: Rick from Walkerton IN
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Socket set
  • 153 of 187 people found this instruction helpful
1. I began by removing the two screws that hold the front panel in place. I then lifted the top free of the front panel and tilted it back to get it out of the way.

2. Using my fingers, I released the tabs that connect the tub cover to the tub. It took some effort to remove the cap("Mechanism") over the bolt connecting the agitator to the agitat... read more

replace broken drive belt

  • Customer: rodney from fairfield bay AR
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 129 of 146 people found this instruction helpful
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run... read more

PUMP MOTOR FAILED

  • Customer: Thomas from Walpole MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 37 of 39 people found this instruction helpful
First, remove the 2 screws that hold the lower front cover in place, remove the cover and disconnect the plug and the ground wires from the pump. Next attach the washing machine drain hose to a wet vac, since even if the machine is empty, there will still be water in the outer tub and the pump. Suck the whole thing dry, remove the 2 bolts that hold the cover... read more