Models > FUF20DUBRWW

FUF20DUBRWW General Electric Freezer - Overview

Get Parts and Repair Help for FUF20DUBRWW

If you know the freezer repair part you need, you can browse the list of all parts on the FUF20DUBRWW, or you can search by name or part description. You can also find your part by where it is located on the FUF20DUBRWW by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FUF20DUBRWW [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.11

Key - Lock

$155.04

Door Gasket

$10.49

TRIM-HANDLE WHITE

$43.14

HANDLE-DOOR WHITE

$23.93

GLIDE-BASKET

$56.33

Defrost Thermostat

The thermostat senses that the heat near the cooling coils has reached the desired temperature.

$35.45

GASKET EVAP.

$18.16

"LIGHT-SIGNAL GREEN"" "

$16.45

RAMP DOOR CLOSURE

$6.41

BEARING-HINGE BOTTOM

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

freezer kept icing up on the coils would only get down to 20 degrees.

  • Customer: Jerry from Elverta CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 3 people found this instruction helpful
unplug the freezer. remove the 2 screws holding the timer, unplug the electrical fitting w/4 prongs. reverse the steps and you are done. read more

Someone Pressed Too Hard On Handle

  • Customer: Doug from Montgomery TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
I removed the plastic caps over the top and bottom retainer screws; removed the screws; removed the broken plastic nipples; placed the new handle in the proper position; re-inserted retainer screws; snapped plastic caps back in place and was finished with the repair. read more

The freezer door was catching when opened and frost was building inside telling me that the seal wasn't good.

  • Customer: Paulette from Great Falls MT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
I called the local GE dealer for repair. The repair person arrived and told me that he could not get the part. The freezer was too old. Then he charged me $60 for coming out. I went online and did a search for parts with the model number above. I found Partselect.com and the diagrams showed which part I needed. It was in stock and I ordered it. My husb... read more