Models > FUF17DPFRWH

FUF17DPFRWH General Electric Freezer - Overview

Get Parts and Repair Help for FUF17DPFRWH

If you know the freezer repair part you need, you can browse the list of all parts on the FUF17DPFRWH, or you can search by name or part description. You can also find your part by where it is located on the FUF17DPFRWH by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FUF17DPFRWH [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.11

Key - Lock

$41.00

Run Capacitor - 220Vac

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$23.93

GLIDE-BASKET

$89.70

PTC Start Relay

Connects into the Capacitor. This part boosts the compressor and shuts off as soon as the motor gets up to the required speed.

$56.33

Defrost Thermostat

The thermostat senses that the heat near the cooling coils has reached the desired temperature.

$35.45

GASKET EVAP.

$16.45

RAMP DOOR CLOSURE

$6.41

BEARING-HINGE BOTTOM

$6.20

SCREW

$176.82

Door Gasket - White

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

freezer kept icing up on the coils would only get down to 20 degrees.

  • Customer: Jerry from Elverta CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 3 people found this instruction helpful
unplug the freezer. remove the 2 screws holding the timer, unplug the electrical fitting w/4 prongs. reverse the steps and you are done. read more

The freezer door was catching when opened and frost was building inside telling me that the seal wasn't good.

  • Customer: Paulette from Great Falls MT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
I called the local GE dealer for repair. The repair person arrived and told me that he could not get the part. The freezer was too old. Then he charged me $60 for coming out. I went online and did a search for parts with the model number above. I found Partselect.com and the diagrams showed which part I needed. It was in stock and I ordered it. My husb... read more

Freezer quit working

  • Customer: James from Sand Point AK
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 1 of 4 people found this instruction helpful
I contacted just answer and Bryan the technician told me the compressor relay or compressor was out. I ordered the relay, installed it and it began working. read more