Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FSG447GHS0 > Parts

FSG447GHS0 Frigidaire Dryer - Parts

All parts for the Frigidaire Dryer FSG447GHS0

Below is a list of all parts for the Frigidaire Dryer FSG447GHS0 - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the FSG447GHS0
15-28 of 96
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.61

Grounding Ball

This grounding ball is used in dryers and works to prevent friction in the rear bearing when the drum rotates. If your dryer is making a squealing, loud, banging noise or will not ...

$118.79

Drive Motor with Pulley

This motor has a double shaft.

$29.81

Idler Arm Assembly

Part may differ in color from image. Please note that this is only a cosmetic difference.

$22.09

Flame Sensor

This part senses the flame for heat allowing the gas valve to open. The most common issue that might arise that would indicate the flame sensor needs to be replaced is your dryer is not giving off enough heat. If your clothes are not drying at a reasonable time, this might be your first indication of an issue. You will need to remove the two screws underneath the lint cover to remove the top of the appliance. Release the door switch wiring, remove the front panel, and remove the belt off the pully. You should now be able to completely remove the drum from the dryer. This will give you access to the sensor for the repair.

$30.30

Door Handle

$19.73

Igniter

This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.

$7.88

Grounding Ball Clip

This grounding ball clip is made of metal. Sold individually.

$6.55

SCREW

Sold individually.

$6.23

SCREW

$28.85

High Temperature Adhesive

This high temperature adhesive is used for installing felt and rubber seals on dryers. The tube contains 1 ounce of product. This adhesive is made to withstand extremely hot temperatures. Before applying the adhesive, ensure that the area is completely clean from any debris and is dry. You may wish to use small clamps to hold the material in place while it dries. If the felt has come loose or broken apart, this may cause your dryer to make loud noise, indicating that new felt or rubber needs to be glued into place. Use gloves to apply glue.

$0.58

Levelling Leg

Sold individually.

$35.22

Seal

Adhesive is sold separately.

$13.54

High Temperature Lubricant

$7.69

Single Clip

Sold individually.

All Parts for the FSG447GHS0
15-28 of 96