FRS6LF7GS4 Frigidaire Refrigerator - Instructions

remoed plastic housing unsnapped board snapped new board in replaced new housing

Simply removed old bearing with the pliers and aligned new beating into the socket.

We adjusted the door bins that were already in he refrigerator and installer the new one.

followed the video and had little or no trouble loosening or tightening bolts or phillips head screws. The only difficulty was removing the spacer on the door itself. Otherwise a piece of cake. Good video and easy to follow instructions.

Turned off the refrigerator, removed the bottom drawer from refrigerator, then removed the glider bars for the drawer on the left side where the filter chamber is. Removed the filter and then removed the plastic peace guarding the filter chamber. Once that was all removed we removed the screws holding the filter base in place. Now that everything was exposed we removed the inlet and outlet lines from the filter base by pushing in the nobs inside the base and pulling the lines out with some slight elbow grease. After that we just proceeded in reverse. We plugged the filter in after the base was secure to make sure that the fix worked. The repair worked like a charm, was relatively simple and now our fridge is all better with water and ice without a large repair bill :o)

Replaced

put them in no tools thanks just wish that they were not so expensive

just snapped part unto door.

The repair literally to 5 minutes. Remove one shelf, slide new one in. Simple repair.

replaced with screws driver and removed the old one put the support.thank for fast service.

Glued it back with model airplane cement. Unfortunately, I ordered a replacement part before I remembered to try the glue.

Thanks for the great service, my part arrived the next day!!

It just slides in place!! The unusual thing was delivery; I ordered it late one afternoon with the least expensive shipping. My wife called the next morning to tell me that she received it and installed it. At most 1/2 day for shipping!!

Removed old water pump and cut off ends of all lines. Plugged them into each water inlet/outlet and turned it on. Instant water to dispenser but took about 6 hours for ice maker to get water. Had to prime the ice maker. Works great and saved a lot of money ordering parts from you. Thanks.

just put it in the old hole. the hard part was getting the old one out. you have to poke the center piece in to remove. otherwise you will break your fridge. then you have to to pull the center piece out before you put new in.