Models > FRS24XGCW1

FRS24XGCW1 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for FRS24XGCW1

If you know the refrigerator repair part you need, you can browse the list of all parts on the FRS24XGCW1, or you can search by name or part description. You can also find your part by where it is located on the FRS24XGCW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for FRS24XGCW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$25.00

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$101.76

Replacement Ice Maker

This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors.

$120.46

Ice Maker Assembly

$12.91

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fahrenheit.

$74.62

Upper Crisper Drawer - Front NOT Included

Front must be ordered separately.

$69.55

Lower Crisper Drawer

This lower drawer does NOT come with the front cover.

$3.59

Crisper Drawer Cover Support

$24.55

Evaporator Fan Blade

$6.13

Screw

This screw is sold individually.

$14.62

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

ICE MAKER STOPPED WORKING

  • Customer: JACK from MESA AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 84 of 90 people found this instruction helpful
IT WAS PRETTY STRAIGHT FORWARD. REMOVE THE TWO SCREWS THAT HOLD THE UNIT TO THE WALL OF THE FREEZER. IN MY CASE, I HAD TO USE A DIFFERENT ICE MAKER THAN WHAT CAME WITH THE FRIG. IN ORDER TO INSTALL THE REPLACEMENT UNIT THEY SENT A WIRE ADAPTOR SO IT WOULD ATTACH TO THE EXISTING WIRING. THAT TOO WAS ALL FINE AND DANDY. THE ONLY PROBLEM WAS THAT THE END O... read more

Broken ice maker

  • Customer: Juan from Miami FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 81 of 113 people found this instruction helpful
Unplugged faulty ice maker, removed two screws holding it to the refrigerator and took it out. Reversed the operation with the new ice maker and after a few minutes presto, we have ice. read more

Clicking sound then within a minute clicking again, not cooling.

  • Customer: Melvin from Semmes AL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 62 of 71 people found this instruction helpful
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby r... read more