Models > FMV156DSA

FMV156DSA Frigidaire Microwave - Overview

Get Parts and Repair Help for FMV156DSA

If you know the microwave repair part you need, you can browse the list of all parts on the FMV156DSA, or you can search by name or part description. You can also find your part by where it is located on the FMV156DSA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$17.66

Grease Filter

Sold individually.

$27.87

Relay Switch

$40.50

Waveguide Cover

$62.79

Glass Cooking Tray

$29.18

Light Bulb - 20W

Sold individually.

$28.68

Turntable Motor

$25.38

DAMPER ASSEMBLY

$63.02

SUPPORT ASSY

$29.64

Door Latch

This black door latch enables the switches to make sure that the door is closed before it operates.

$25.38

LEVER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Timer would run but the microwave won't start

  • Customer: Tim from Chicago IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 34 of 43 people found this instruction helpful
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up. read more

Wave guide cover was cracked. Oven started to spark and make popping noises when in use.

  • Customer: amy from corona CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 20 of 27 people found this instruction helpful
Part arrived in one day. Old part snapped right out and new snapped right in. One minute repair with no more sparking and no need to invest in a new microwave... which is what I thought I was going to have to do. read more

Microwave would count down but not run

  • Customer: Betty from Kimball TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 16 of 21 people found this instruction helpful
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the bad switch with the ... read more