Models > FGP355VW2

FGP355VW2 Whirlpool Range - Overview

Get Parts and Repair Help for FGP355VW2

If you know the range repair part you need, you can browse the list of all parts on the FGP355VW2, or you can search by name or part description. You can also find your part by where it is located on the FGP355VW2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for FGP355VW2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Cover Screw

Sold individually.

$18.07

2 Piece Broiler Pan

$36.73

Flat-Style Oven Igniter - Bake/Broil

This igniter doesn't come with the bracket or the connector. It can be used for either the bake or broil in your appliance.

$2.70

Screw

This screw is sold individually.

$18.56

Oven Thermostat Knob

$16.53

Timer Knob

$3.83

Screw - #10 - 32x1/2

Sold Individually.

$4.45

Thermostat Bulb Clip

$29.40

Suface Burner Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

STOVE WORK BUT YOUR OVEN WON'T GET HOT ?

  • Customer: Brian from Cumming GA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 9 of 10 people found this instruction helpful
IF YOUR STOVE WORK'S BUT YOUR OVEN WON'T GET HOT IT IS YOUR IGNIGTER THE IGNIGHTER IN PROPER WORKING CONDITION SENDS A SIGNAL TO THE GAS VALVE SAYING LET THE GAS FLOW ITS OK. WHEN THE IGNIGHTER QUITS WORKING IT WON'T LET THE GAS FLOW AND YOUR OVEN WILL NOT GET HOT. IT IS AN EASY FIX. JUST PULL OUT ALL OF INTERIOR PARTS THE RACKS AND THE BOTTOM HEAT SHIELD TH... read more

Ignitor did not spark when turning the know

  • Customer: Richard from Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that attach to the oven light... read more

oven would not light

  • Customer: MATTHEW from SAN CLEMENTE CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
Removed oven door and burner guard. Removed screws holding ignitor bracket and small panel beneath oven door. Disconnected ignitor wires behind panel and pulled out ignitor. Removed old ignitor from bracket and inserted new unit. Fed wires back down thru tubing and screwed in bracket. Connected wires and replaced panel. (Note: old ignitor glowed but would no... read more