Models > FGMC3065KBA

FGMC3065KBA Frigidaire Microwave - Overview

Get Parts and Repair Help for FGMC3065KBA

If you know the microwave repair part you need, you can browse the list of all parts on the FGMC3065KBA, or you can search by name or part description. You can also find your part by where it is located on the FGMC3065KBA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for FGMC3065KBA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$28.02

Oven Temperature Sensor

Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porc...

$3.51

Main Terminal Block Kit

$27.87

Relay Switch

$18.75

Light Bulb Lens

This lens covers the interior oven light bulb.

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$97.05

Inner Oven Door Glass

This is also called the heat barrier glass.

$25.05

COVER

$63.02

SUPPORT ASSY

$30.25

Light Lens Retainer Clip

This retainer secures the light lens to the oven cavity.

$100.16

Cooking Tray

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 51 of 73 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Timer would run but the microwave won't start

  • Customer: Tim from Chicago IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 37 of 50 people found this instruction helpful
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up. read more

Cracked oven door inner glass

  • Customer: Mitch from Fernandina Beach FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 29 of 43 people found this instruction helpful
Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door from the inside. The... read more