Models > FGMC2765KBA

FGMC2765KBA Frigidaire Microwave - Overview

Get Parts and Repair Help for FGMC2765KBA

If you know the microwave repair part you need, you can browse the list of all parts on the FGMC2765KBA, or you can search by name or part description. You can also find your part by where it is located on the FGMC2765KBA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for FGMC2765KBA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$28.02

Oven Temperature Sensor

Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porc...

$3.51

Main Terminal Block Kit

$27.87

Relay Switch

$18.75

Light Bulb Lens

This lens covers the interior oven light bulb.

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$4.38

SCREW

$31.32

Broiler Pan

Pan Only. Must order insert separately.

$52.21

Broiler Pan Grate Insert

Broiler pan sold separately.

$7.54

SPACER

$100.16

Cooking Tray

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 44 of 63 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Timer would run but the microwave won't start

  • Customer: Tim from Chicago IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 32 of 40 people found this instruction helpful
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up. read more

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 24 of 45 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more