Models > FGHD2433KF1 > Instructions

FGHD2433KF1 Frigidaire Dishwasher - Instructions

All installation instructions for FGHD2433KF1 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the FGHD2433KF1
286-294 of 294
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

leak at door

  • Customer: James from Willis TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 0 of 0 people found this instruction helpful
Bottom door gasket. Pulled old door seal on bottom of door out with pliers. Cleaned area groove with 1" putty knife to remove caked up soap. Pushed in new gasket by hand. had to do 2x due to missed channel lip on 1st try, it came all the way out to the front of the door. For the tub gasket, just pulled old gasket out, cleaned area with putty knife pushed in new gasket cutting extra off with scissors.

Upper wash arm not working. Not getting proper water fill level.

  • Customer: jens from west lafayette IN
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Disconnected washer & replaced water inlet valve & supply hose. Releveled washer.

Dispenser would not dispense.

  • Customer: Johnie from Aztec NM
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Removed 4 screws on door cover, 6 screws on dispenser 4 wires and reinstalled new one. Done less than 20 minutes.

Lower spray arms were curving upward because of drying heater element, catching on lower rack, and wasn't turning or cleaning anything.

  • Customer: David from Westfield MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Pulled the bent spray arm straight out, snapped the new arm back on. Took 10 seconds, and no tools needed. Wish all repairs were that easy....

No water

  • Customer: Bret R. from Angola IN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Wrench set, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Tested main water supply first and it checked out, next thing was the valve got a new one took old one off, flushed the line a few times to get dirty deposited water out, stuck the new inlet valve on and ran the dish washer and it worked, really a pretty easy thing to do anybody can do it and it will save you a couple hundred bucks in the repair mans labor and his cost for parts, deffinetly a must do yourself job. Got my part in two days from when I ordered it.

dishwasher would stop after about one minute and give a code on the screen

  • Customer: jeff from beach park IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Looked up the code on the internet and it said it was the vent fan, was easy to pull out and replace. Saved hundreds

Bottom door gasket had fallen out.

  • Customer: Flo from Hannibal MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I had tried to put the old gasket back in place while waiting for the new to arrive and in doing so, the gasket had gone up beyond reach.We removed the screws on the inside of the door and I was able to reach and remove the old gasket. After replacing the screws, I then simply slid the new gasket into place. Easy! If I can do it, anyone can. Flo

DOOR LEAKING

  • Customer: willis w from broomes island MD
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
ALL I HAVE TO SAY IS PAETS SELECT IS THE BEST COMPANY I HAVE DELT WITH IN THE LAST 20 YEARS

the tub was leaking at the right front corner

  • Customer: Raymond from El Paso TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
just pushed it into the crevice with my thumb
All Instructions for the FGHD2433KF1
286-294 of 294