Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FGF337ECC > Parts

FGF337ECC Frigidaire Range - Parts

All parts for the Frigidaire Range FGF337ECC

Below is a list of all parts for the Frigidaire Range FGF337ECC - Free Standing, Gas. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the FGF337ECC
15-28 of 119
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.02

Steel Washer

This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter ...

$52.27

Oven Door Seal with Clips

Also known as gasket.

$29.24

Oven Light Socket

The oven light socket allows you to screw in a light bulb so that you can see the inside of your oven. The light socket is located in the back of your oven, so you will need to rem...

$6.42

Igniter/Orifice Mounting Screw

$8.72

Clock Mounting Bracket

Sold individually.

$6.34

Screw

Sold Individually.

$6.15

Wafer Head Screw

$5.48

Leveling Leg

This part is sold individually. The leveling leg is black in color and measures approximately 2 inches in length. It is made of plastic. The leveling leg is found underneath your range and may crack or wear down over time. This will need to be replaced if it has broken or gone missing. If you notice your oven is wobbling or uneven it may be due to the leveling leg needing to be replaced. This part can be adjusted to accommodate different heights due to uneven flooring. This is a genuine OEM part sourced directly from the manufacturer.

$44.44

Top Door Trim

$52.36

Rear Burner Igniter/Orifice Assembly

$157.93

Burner Grate - Set of 4 - Black

Sold individually.

$75.61

Oven Bottom Panel

$64.35

Inner Door Glass

$42.59

Spark Module

This spark module or range spark module, is used in ranges and ovens. The spark module monitors and controls the spark to ignite the surface burner in a range. It does this by sending a certain amount of current to the igniter to produce that spark. If you are not getting any spark to the igniters then it is best you replace this part with a new spark module. To repair, first remove the access panel at the back of your range with a 1/4 inch nut driver to take the screws out. Next, disconnect the power harness that connects the range to the power cord to access the spark module. Take wires off using needle nose pliers and pull the spark module off the range. Match and hook up the wires to the new part. Refer to the manual provided by the manufacturer for further installation instructions and guidance.

All Parts for the FGF337ECC
15-28 of 119