Models > FGBM185KFC

FGBM185KFC Frigidaire Microwave - Overview

Get Parts and Repair Help for FGBM185KFC

If you know the microwave repair part you need, you can browse the list of all parts on the FGBM185KFC, or you can search by name or part description. You can also find your part by where it is located on the FGBM185KFC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$17.66

Grease Filter

Sold individually.

$27.87

Relay Switch

$62.79

Glass Cooking Tray

$63.02

SUPPORT ASSY

$29.18

Light Bulb - 20W

Sold individually.

$23.41

BRACKET

$5.52

SCREW

$5.52

SCREW; 3MM X 8MM

$41.16

Switch Holder

Switches are NOT included. Holder only.

$25.38

SPRING

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Timer would run but the microwave won't start

  • Customer: Tim from Chicago IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 36 of 49 people found this instruction helpful
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up. read more

microwave wouldn't turn on but timer worked.

  • Customer: Steve from Moorhead MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 18 of 28 people found this instruction helpful
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a 12 volt battery and... read more

Microwave would count down but not run

  • Customer: Betty from Kimball TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 16 of 23 people found this instruction helpful
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the bad switch with the ... read more