Models > FGB24L2ECB

FGB24L2ECB Frigidaire Oven - Overview

Get Parts and Repair Help for FGB24L2ECB

If you know the oven repair part you need, you can browse the list of all parts on the FGB24L2ECB, or you can search by name or part description. You can also find your part by where it is located on the FGB24L2ECB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for FGB24L2ECB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$28.02

Oven Temperature Sensor

Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porc...

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$185.52

Flat Glow Bar Igniter

$34.64

Rack

$25.96

Door Hinge Receptacle

Sold individually.

$25.96

RECEPTACLE

$17.52

Oven Light Rocker Switch

$30.84

USE WCI 5303202116

$27.12

GASKET

$7.25

Hex Nut

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 51 of 73 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Clocktimer went out, why I don't know.

  • Customer: Rosemary from Glendale AZ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 3 people found this instruction helpful
Turned off power and gas. took off top brace held on with four small phillips screws.Then pulled face plate loose from front of Clock/timer. Then removed four large phillips screws holding the brace for the Clock/timer.Then removed the second set of four screws from each corner of the Clock/timer and disconnected the power wire attached to the clock/timer. P... read more

Inside glass just exploded when pre heating oven

  • Customer: George from Cleveland OH
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 3 of 6 people found this instruction helpful
I unscrewed 4 screws and took the door apart. The only trouble was I did not pay attention to the way the spacer was positioned. When I put the door back together I really had to look at the way it fit in the main part of the door. I had to use 2 small pieces of tape to hold the glass in place since the door was still atached to the oven and not laying flat.... read more