Models > FFU2064DW1 Frigidaire

FFU2064DW1 Frigidaire Freezer - Overview

Get Parts and Repair Help for FFU2064DW1

If you know the freezer repair part you need, you can browse the list of all parts on the FFU2064DW1, or you can search by name or part description. You can also find your part by where it is located on the FFU2064DW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for FFU2064DW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FFU2064DW1 [Viewing 4 of 4]

$10.15

Thermostat

This thermostat regulates and keeps the temperature at a constant temperature for the freezer section.

$19.73

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$6.68

Freezer Door Key

This metallic freezer door key is used for most upright or chest freezers.

$19.96

Defrost Timer - 120V

This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

$106.52

Door Gasket

This white door gasket is used to seal the freezer door when closed to keep the cool air inside and the room air out.

$23.91

Evaporator Fan Blade

$8.00

Adjustable Leveling Foot - Black

Sold Individually.

$37.43

Evaporator Fan Motor with Wire Harness - 115V

This evaporator fan motor is located in the back of the freezer, and circulates air over the coils. These coils will convert the heat into cool air, which is then circulated.

$4.38

SCREW

$4.95

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

wouldnt freeze/compressor not running

  • Customer: Anthony from Daleville AL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 30 of 43 people found this instruction helpful
Unplug cord. Remove the retaining clip. Remove the two wires by sticking small screwdriver in hole to release the clips holding the wires in. very easy took less than five minutes read more

Temp alarm sounding and food on top shelves partially thawed

  • Customer: Wayne from Forest Hill MD
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 12 of 12 people found this instruction helpful
After silencing the alarm, it seemed to be running as normal without any unusual noises, but food was starting to thaw from the top shelf on down and condensation was dripping from the roof. We were able to place most of the food in 2 large ice chests and then the rest in the freezer compartments of 2 fridges we have in the house. I then turned down the te... read more

freezer compressor ran continuously and freezer getting colder and colder.

  • Customer: john from hurst TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 12 of 14 people found this instruction helpful
Repair was quick and easy. I removed the frozen food in the bottom so the back panel could be removed. The temperature comtrol is attached to the back of that panel. It has a metal wire with a capillary tube on the end to sense the temperature. I just installed it exactly like the old one came out. Be sure and don't get the wires mixed up. Someti... read more