Models > FFHB2750TD3 > Symptoms > Ice maker not making ice

Parts That Fix Frigidaire Refrigerator FFHB2750TD3 Ice maker not making ice

Ice maker not making ice is a commonly reported symptom for the FFHB2750TD3 Frigidaire Refrigerator, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your FFHB2750TD3 Frigidaire Refrigerator that will fix Ice maker not making ice. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!

1 Ice Maker Assembly
Fixes Symptom 68% of time
Ice Maker Assembly – Part Number: 243297613
★★★★★
★★★★★
29 Reviews

Rated by 7 customers 

  

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.   

This is a genuine Frigidaire part for your refrigerator. This is an ice maker, which connects to the water lines to provide fresh ice. The most common reason to replace this part is if your refrigerator is leaking, or it will not produce ice cubes. Be sure to disconnect the power to your refrigerator before beginning this repair.

$ 106.98
  In Stock
PartSelect Number PS16221322
Manufacturer Part Number 243297613

Customer Repair Stories

Not making ice and leaking water from aebecause the icemold in the ice maker cracked

Removed the trough that catches the ice.. two philips screws to take the front cover off. Side and bottom. Than quarter inch to remove cover over wires. Unplug ones to ice maker. Slide out a little and down. May be a zip tie in the back cut with sheet rock knife. Reverse to install.
  • Dave from WEST DEPTFORD, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Screw drivers
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!

Ice maker was not working

Simple three steps... 1) There's an front section to the ice-maker to take off. One Phillips screw is on the side, one screw is underneath near the inside of the refrigerator wall. Just unscrew and store. 2) There's a small plastic unit just inside the ice maker to take out. It's held in by a small nut that requires about a 4" extension to reach. (You may be able to unscrew the nut with small needle-nose pliers). Just unscrew and take out the unit - the unit functions just to keep the ice maker wiring in place. 3) The wiring looks a mess, but there's just one wiring connector to the ice maker assembly. Unsnap it. The ice maker is not screwed in, it just slides in -- reach in and pull the assembly straight out; when it stops, lower it a bit and it will come free. Reverse the instructions to install the new unit.
Read less
  • Richard from N CALDWELL, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
42 of 59 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
2 Water Inlet Valve - 4 Coil
Fixes Symptom 17% of time
Water Inlet Valve - 4 Coil – Part Number: 242253002
★★★★★
★★★★★
5 Reviews

Rated by 2 customers 

  

Really Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.   

The water inlet valve supplies water to the refrigerator ice maker and water dispenser. This part works with the following brands: Frigidaire, White Westinghouse, Kelvinator, Gibson, Kenmore, Sears, Tappan, & Electrolux. Possible Repair Solution For: Leaking water, water will not dispense, ice maker does not make ice, ice maker does not dispense ice. This is an authentic water inlet valve (4 coil), which works with refrigerators.

$ 153.89
  In Stock
PartSelect Number PS7321353
Manufacturer Part Number 242253002

Customer Repair Stories

No water to the ice maker or water tap.

Removed valve unplugged valve from electric removed water lines from valve and then reverse procedures then turn on water and use.That was it.
  • Laura from LANCASTER, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!

Not making ice in both ice maker or dispensing water

To confirm my diagnosis I first replace the filter still no water flow.
Check water supply from the wall valve: ok
Remove the entire inlet valve assembly and sit it over a small bucket.
Disconnect the tubing from the bottom of the 1st selenide valve: this is the one leading to the filter.
Place cup under water dispenser and activate dispenser. No water discharge from inlet valve confirm valve is bad.
Install the new valve matching the colored tubing with the color on each inlet valve.
Re-connect the water supply place container under water dispenser and activate: There will be a large gush of air then water. Dispense aprox 1 gallon of water to confirm all the air is purged from the system. Your refrigerator is now back to dispensing water and making ice.
Good luck everyone - Neville
Read less
  • Neville from LITHONIA, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Wrench (Adjustable)
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
3 Refrigerator Water Filter - White
Fixes Symptom 10% of time
Refrigerator Water Filter - White – Part Number: EPTWFU01
★★★★★
★★★★★
13 Reviews

Rated by 6 customers 

  

Easy 

15 - 30 mins 

Ratings submitted by customers like you who bought this part.   

This OEM refrigerator filter is for french door and side-by-side door types and is located in the back, top-right of your appliance. By absorbing heavy metals, pharmaceuticals, pesticides, chlorine, and much more, this filter provides delicious and healthy drinking water. This filter measures 2 inches deep, 9 inches high, 2 inches wide, and weighs 0.9 lbs. The installation is quick and easy with a push and twist feature. Don't forget to run water through the dispenser for about three minutes or 1.5 gallons to prepare the filter before use. For best performance replace this filter every six months.

$ 82.40
  In Stock
PartSelect Number PS11704498
Manufacturer Part Number EPTWFU01

Customer Repair Stories

WATER FILTER EXPIRED

REPLACED WITH NEW.
HOWEVER, THE WATER FILTER INDICATOR STILL SAYS
'REPLACE'. THERE IS NO LEAKAGE, BUT IT APPEARS LIKE THE NEW CARTRIDGE IS NOT COMPLETELY INSERTED. I'VE TRIED REMOVING AND REPLACING THE NEW CARTRIDGE SEVERAL TIMES, BUT IT STILL SAYS 'REPLACE'.
INCIDENTALLY, THIS WAS THE SECOND ORDER OF THE CARTRIDGE AND LAST TIME I GOT TWO, AND THEY BOTH FIT FINE! WITH THIS ORDER I GOT JUST ONE.
Read less
  • Bo from SUN CITY WEST, AZ
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
7 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!

Change filter

When removing existing filter you will experience some resistance at the 10-4 position which requires a little extra pressure to reach the 9-3 position.
  • Claude from MARYVILLE, TN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
19 of 34 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
4 Refrigerator Ice Dispenser Solenoid
Fixes Symptom 5% of time
Refrigerator Ice Dispenser Solenoid – Part Number: 241675704
★★★★★
★★★★★
4 Reviews

Rated by 3 customers 

  

Easy 

1- 2 hours 

Ratings submitted by customers like you who bought this part.   

The cube solenoid allows cube or crushed ice to be dispensed on demand. 120V 60Hz

$ 88.82
  In Stock
PartSelect Number PS8691994
Manufacturer Part Number 241675704

Replacing your Frigidaire Refrigerator Refrigerator Ice Dispenser Solenoid

Replacing your Refrigerator Ice Dispenser Solenoid

Customer Repair Stories

ice maker is stuck on crushed ice.

We had someone to come and look at it and we were told it was the solenoid valve. The repairman unstuck it for us and said when it does it again, he would have to order the part. We took it upon ourselves to order the part and DIY. We replaced the part that we were told was the problem and "guess what" it's still not fixed. It's still shooting out crushed ice. Will have to call repair guy back out here to see what we did wrong.
Read less
  • Mary from MAGNOLIA, AR
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Nutdriver, Screw drivers
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!

Ice maker wouldn't change from crushed to cubed ice

First I pulled the ice tray out so I could see the solenoid housing/ice tray support(1 unit). Below the ice tray there are 2 screws that hold the solenoid housing/ice tray support. After removing those the assembly lifts up so you can see the wiring harness to disconnect. I pulled it out and removed the 2 screws to open it up. There is 2 screws holding the solenoid in place and one ground wire. This was an easy fix and I know I saved a lot of money.
Read less
  • robert from sioux falls, SD
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Screw drivers
56 of 85 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Back to Top