Models > FFGF3047LSE

FFGF3047LSE Frigidaire Range - Overview

Get Parts and Repair Help for FFGF3047LSE

If you know the range repair part you need, you can browse the list of all parts on the FFGF3047LSE, or you can search by name or part description. You can also find your part by where it is located on the FFGF3047LSE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for FFGF3047LSE parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FFGF3047LSE [Viewing 6 of 6]

$92.48

Electronic Oven Clock/Timer

$25.73

Natural Gas to Liquid Propane Conversion Kit

$26.72

Temperature Probe

$44.14

Oven Rack

Sold individually.

$7.64

ANTI TIP KIT

$5.27

Screw

Sold Individually.

$7.09

Foot Leveling Leg

Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.

$7.04

ORIFICE

$44.55

Oven Door Seal with Clips

Also known as gasket.

$5.29

Igniter/Orifice Mounting Screw

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Safety valve would not open

  • Customer: Ed from Darby PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 61 of 78 people found this instruction helpful
I am an HVAC tech by trade so it wasn't difficult to diagnose problem with safety valve. The hard part was being without an oven for a week. Repair was simple and effective--oven works good as new.
Shut off gas and unplugged oven. Removed floor of oven between broiler and bake section, used wrenches to disconnect gas line from safety valve in back of... read more

Stove was set up for natural gas and needed to be converted to LP

  • Customer: Ed from Orange TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 70 of 110 people found this instruction helpful
The LP conversion kit contained very good, detailed instructions. I replaced the gas orifices, took off the bottom door and adjusted the regulator.

Used the screwdriver to adjust the low flame and everything was done. read more

We had a transformer go out in our block and made a surge which blew out the electronic oven control

  • Customer: Alberto from Houston TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 47 of 50 people found this instruction helpful
The repair of the oven was really easy . I removed a total of 7 screws with a 1/4 inch nut driver to remove the back cover of the instrument panel. I then unplugged the wires from the from the oven control and with a phillups screw driver I removed 4 screws that hold the oven control,the face plate with the words on it has to be taken off the old control an... read more