Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FEX831CS0 > Parts

FEX831CS0 Frigidaire Washer Dryer Combo - Parts

All parts for the Frigidaire Washer Dryer Combo FEX831CS0

Below is a list of all parts for the Frigidaire Washer Dryer Combo FEX831CS0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the FEX831CS0
29-42 of 185
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$24.25

Snubber Ring

The snubber ring on your washing machine mounts at the base, under the support. If you notice that your washing machine is vibrating, shaking, or moving during the wash cycle, you ...

$7.69

Single Clip

Sold individually.

$28.60

Terminal Block Kit

This kit includes 3 screws and 3 terminals.

$72.87

Water Valve - 115V

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

$48.78

Spin Bearing

The spin bearing, used for your washer, is located at the bottom of the outer tub near the transmission. The spin bearing carries the transmission shaft in the drive system, theref...

$60.27

Agitator

$34.39

Door Gasket

The gasket is used to help keep in the hot air in the dryer from escaping and to prevent the cool air from entering in to the dryer.

$8.47

Upper Spin Bearing Washer

The upper spin bearing for a washer can solve many issues such as loud and odd noises, or leaking water. Replacing the spin bearing could solve these issues. The tools needed for this replacement are screwdrivers, a socket set, and a putty knife. To repair, first lift the top of the washer and remove the screws at the bottom of the front panel to pull away. Next, pull off the dispenser cover, cup, and agitator. Detach switch tube from the tub cover and remove tub cover, then use the 1/2 inch socket to remove the trunnion bolts and pull out inner tub. For the rest of the installation instructions, refer to the diagram provided by the manufacturer. Remember to unplug the appliance from the power source as a safety precaution.

$52.68

Water Level Switch

$9.26

CLAMP

Clamp used for hoses.

$4.04

Push-in Fastener

$6.71

Bracket Screw

Sold individually.

$29.13

Horizontal Spring

This is a horizontal spring, but you may know it as a suspension spring, and it is a part for your washing machine. Its function is to stabilize the outer tub by keeping it balance...

$31.99

Handle

This handle is used on washer/dryer combos.

All Parts for the FEX831CS0
29-42 of 185