Models > FES375VW1

FES375VW1 Roper Range - Overview

Get Parts and Repair Help for FES375VW1

If you know the range repair part you need, you can browse the list of all parts on the FES375VW1, or you can search by name or part description. You can also find your part by where it is located on the FES375VW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$31.88

Bake Element

Please note: This is a substitute from the original part. It may physically look different, but will still function the same. This bake element is found on the bottom of the oven.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$37.18

Broil Element

$36.89

Oven Light

$85.05

Solid Surface Burner - 8"

$27.23

Rocker Switch - Black

This rocker switch can be used for both the oven selector and/or the oven light.

$67.82

Solid Surface Burner - 6"

$2.70

NUT

$5.55

SCREW

$166.05

Electronic Relay Board

This board sends information (such as temperature of oven, bake, broil) to the main control board during specific functions.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Baking element in the bottom of the stove apparently shorted out and partially melted

  • Customer: Timothy from Salem OR
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers
  • 35 of 35 people found this instruction helpful
First I turned off the circuit breaker on the house electricity panel. I removed the two screws that held the element in place in the oven. There were two wires connected to the element by spade plugs that were free floating in a fiberglass pad. I reconnected the spade plugs and put the element back in place and put back in the two screws. This procedur... read more

Bake element broke/burned out

  • Customer: edward from hamburg NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 6 people found this instruction helpful
un-screwed 2 scrws and pulled out the old one and pulled off the 2 wires put the new one on the floor of the oven and hooked-up the 2 wires and pushed it in the back wall and replaced the 2 screws! done maybe 5 minutes read more

Broiler burned out

  • Customer: David from Lewisburg TN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 4 of 4 people found this instruction helpful
The Job didn’t take very long at all. I pulled the unit out and unplug it before I started the repair. I had to remove the back two access cover plates to get to the two wire leads that connect the broiler. I don’t believe there was enough wire to be able to do it all from the front side. Next I disconnected the two wires that connected it while remembering ... read more