Models > FES356RD4

FES356RD4 Roper Range - Overview

Get Parts and Repair Help for FES356RD4

If you know the range repair part you need, you can browse the list of all parts on the FES356RD4, or you can search by name or part description. You can also find your part by where it is located on the FES356RD4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for FES356RD4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$3.96

Rear Drawer Glide

$43.62

Oven Rack

Sold individually.

$66.29

Sensor

This temperature sensor detects the temperature within the oven cavity.

$48.13

Bake Element

This bake element is found on the bottom of the oven.

$4.11

SCREW

$17.77

Terminal Block

$42.22

Infinite Switch - 8"

$2.70

SCREW

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The burner would keep heating after turning off the switch

  • Customer: RON from KAUFMAN TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 22 of 24 people found this instruction helpful
Start by turning off the power to the range.
It was fairly easy to take the "Control Deck" off the top of the range by removing about 8 screws. I leaned the deck forward without removing any wires except a green ground that was held on by one of the screws.
There are two small screws under the switch knob holding the Infinite Switch to the panel. ... read more

Baking element on stove wouldn't heat

  • Customer: Reggie from Piedmont SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 19 of 22 people found this instruction helpful
Went online and located the correct part, which I had shipped to me next day. The part arrived I removed the two screws which held the element in place, unclipped the two wire leads, then replaced old element with the new one, reattached wire clips then screwed new element in place. All done 10 min. read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more