Models > FES355YW2

FES355YW2 Roper Range - Overview

Get Parts and Repair Help for FES355YW2

If you know the range repair part you need, you can browse the list of all parts on the FES355YW2, or you can search by name or part description. You can also find your part by where it is located on the FES355YW2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for FES355YW2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.66

Bake Element - 2600W 240V

This closed hinged style bake element is 15-3/4 inches long and 16-5/8 inches wide. The terminal depth is three inches and they are 1-3/4 inches apart.

$8.22

Surface Burner Plug-In Block Kit

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.

$26.93

Surface Burner - 8" - 2600W

NOTE: The manufacturer recommends that you replace the burner receptacle at the same time.

$24.60

Standard Y-Frame Surface Burner - 6" - 1500W

The manufacturer suggests replacing the receptacle at the same time.

$40.67

Surface Burner Element Switch - 8"

This control switch controls the stove top 8" surface burner.

$28.25

Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$7.65

Drip Bowl - 6" - Black

Sold individually.

$8.61

8" Drip Bowl - Black

This black porcelain drip bowl with a hole in the bottom is intended for use with some electric ranges and cooktops.

$41.79

Broil Element - 208V

This broil element is found on the roof of the oven and has push-on terminals.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

lower back element stopped working

  • Customer: Bradley from Lexington OK
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 448 of 525 people found this instruction helpful
I got the model number and ordered a replacement element from partselect, was shipped quickly and I installed it in about 30 minutes, it now works great read more

Oven stopped heating.....

  • Customer: Richard from Pattonsburg MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 221 of 370 people found this instruction helpful
Removed the oven racks....

Removed the two screws holding element in place...

Disconnected spade lug connectors from old heating element.

Connected spade lug connectors to new heating element.

Reinstalled screws.....replaced oven racks....mission acomplished! read more

The bake element stopped working.

  • Customer: Harry from Charlotte NC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 191 of 331 people found this instruction helpful
First I cut off the power to the stove and double-checked to make sure no current was flowing to the unit. There were two screws attaching the bake element plate to the oven. I unscrewed the two screws and carefully pulled the bake element away from the oven exposing the contact wires. I carefully loosened the wire contacts from the bake element, slid the b... read more