Models > FEC6X8XHSA

FEC6X8XHSA Frigidaire Cooktop - Overview

Get Parts and Repair Help for FEC6X8XHSA

If you know the cooktop repair part you need, you can browse the list of all parts on the FEC6X8XHSA, or you can search by name or part description. You can also find your part by where it is located on the FEC6X8XHSA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FEC6X8XHSA [Viewing 4 of 4]

$5.62

SCREW

$146.92

Surface Burner Element with Limiter - 6" - 1200W

$47.34

KNOB

$31.64

BUSHING

$305.37

Dual Burner Element with Limiter - 8"

$105.64

Surface Burner Switch

$18.64

Retainer Bracket

$5.71

SCREW

$4.61

SPACER

KNOB-SURFACE UNIT

Common Symptoms of the FEC6X8XHSA [Viewing 1 of 30]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned out burner

  • Customer: Lori from Winter Haven FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 31 of 39 people found this instruction helpful
First we removed two screws under the rim of the range top to open the lid. Lifted the lid and removed the screws from the bracket that holds the elements, Be careful with the clips that hold the element in, if you break them or bend them there aren't any more! Also note which holes they were in, they are marked according to the different sizes of element... read more

Dual radiant burner kaput.

  • Customer: Michael from Spokjane Valley AL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 12 people found this instruction helpful
Removed trim screws,(4) , lifted range top and removed the element after taking a picture of same. then disconnected the wires. I was upset because the new element had a different wire configuration. I put it in anyway in spite of your warning of not being able to return it if it didn't work. I fired it up and it did not work correctly. After a couple ... read more

Burner eye would only produce High Heat on all settings

  • Customer: scot from keller TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 5 of 18 people found this instruction helpful
Ordered a new Surface Burner Switch to replace the failed unit.
When I opened the burner lid, I could see the insulation on all the wiring for the burners had fallen apart and wiring was exposed. The wiring for all 4 burners was exposed as the insulation had deteriorated and fallen off over 80% of the circuits. It was just blind luck there was not a fi... read more