Models > FEC3X9XCSD

FEC3X9XCSD Frigidaire Cooktop - Overview

Get Parts and Repair Help for FEC3X9XCSD

If you know the cooktop repair part you need, you can browse the list of all parts on the FEC3X9XCSD, or you can search by name or part description. You can also find your part by where it is located on the FEC3X9XCSD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FEC3X9XCSD [Viewing 4 of 4]

$145.87

Surface Burner Element with Limiter - 6" - 1200W

$159.50

Dual Infinite Switch Kit

$47.34

KNOB

$105.64

Surface Burner Switch

$31.64

BUSHING

$179.96

ELEMENT-SURFACE - Dual

KNOB-SURFACE UNIT

$5.73

SCREW

$28.98

LAMP

ELEMENT-SURFACE

Common Symptoms of the FEC3X9XCSD [Viewing 1 of 41]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned out burner

  • Customer: Lori from Winter Haven FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 25 of 32 people found this instruction helpful
First we removed two screws under the rim of the range top to open the lid. Lifted the lid and removed the screws from the bracket that holds the elements, Be careful with the clips that hold the element in, if you break them or bend them there aren't any more! Also note which holes they were in, they are marked according to the different sizes of element... read more

Burner eye would only produce High Heat on all settings

  • Customer: scot from keller TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 4 of 16 people found this instruction helpful
Ordered a new Surface Burner Switch to replace the failed unit.
When I opened the burner lid, I could see the insulation on all the wiring for the burners had fallen apart and wiring was exposed. The wiring for all 4 burners was exposed as the insulation had deteriorated and fallen off over 80% of the circuits. It was just blind luck there was not a fi... read more

Element would not heat up

  • Customer: Everett from Colchester CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Removed 2 screws located underneath the front lip of the range top. Lifted range top and supported. Removed the 2 screws at either end of the support bracket. This bracket holds the elements in position. Be careful not to let the elements fall out when removing. The elements are now free to replace. Swap out the old with the new and be sure to reconnect the ... read more