Models > FEC3X7XAT1

FEC3X7XAT1 Frigidaire Cooktop - Overview

Get Parts and Repair Help for FEC3X7XAT1

If you know the cooktop repair part you need, you can browse the list of all parts on the FEC3X7XAT1, or you can search by name or part description. You can also find your part by where it is located on the FEC3X7XAT1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FEC3X7XAT1 [Viewing 1 of 1]

$29.30

Burner Switch Kit

$8.44

USE MCN TJ114

$145.87

Surface Burner Element with Limiter - 6" - 1200W

$163.16

Radiant Burner Element with Limiter - 8" - 2200W

$179.96

ELEMENT-SURFACE - Dual

$26.28

KNOB-SURF ELEM

$5.73

SCREW

$28.98

LAMP

DISCONTINUED

$6.41

SPACER-ELEMENT

Common Symptoms of the FEC3X7XAT1 [Viewing 1 of 149]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned out burner

  • Customer: Lori from Winter Haven FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 25 of 32 people found this instruction helpful
First we removed two screws under the rim of the range top to open the lid. Lifted the lid and removed the screws from the bracket that holds the elements, Be careful with the clips that hold the element in, if you break them or bend them there aren't any more! Also note which holes they were in, they are marked according to the different sizes of element... read more

rf burner was not working

  • Customer: Neil from Jessup PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 22 of 29 people found this instruction helpful
First I removed 2 screws that held the stove top in place. Raised the stove top and support it. Then, I removed the hold down spring for the burner and removed three wires from the old burner. I found that the connector on the white wire was spread open too much so I crimped it closed for a better fit on the terminal. I reattached the three wires, put the ho... read more

High heat reluctant to turn down.

  • Customer: George from New Port Richey FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 14 of 15 people found this instruction helpful
Most of the job is simple fastener mechanics.
Use a nut driver or Phillips screwdriver. Remove rear panel.

Pull out control knob. If it is stuck, wrap a small rag around the back of it and pull the rag steadily.

Carefully match marked terminals on the replacement switch with those on original. Switch terminals may not be in the sa... read more