Models > FEC32C4ASA

FEC32C4ASA Frigidaire Cooktop - Overview

Get Parts and Repair Help for FEC32C4ASA

If you know the cooktop repair part you need, you can browse the list of all parts on the FEC32C4ASA, or you can search by name or part description. You can also find your part by where it is located on the FEC32C4ASA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.51

Drip Bowl - 8"

$3.51

Chrome Drip Bowl - 6"

Sold individually.

$29.30

Burner Switch Kit

$27.61

Single Control Knob

This is only 1 knob and is sold individually.

$92.11

Surface Burner Coil Element - 8" - 2100W

$0.74

LENS

$25.54

TERMINAL BLOCK

$7.64

BUSHING

$19.37

BRACKET-BLOCK

LIGHT-INDICATOR ROU

Common Symptoms of the FEC32C4ASA [Viewing 1 of 120]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

High heat reluctant to turn down.

  • Customer: George from New Port Richey FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 15 of 17 people found this instruction helpful
Most of the job is simple fastener mechanics.
Use a nut driver or Phillips screwdriver. Remove rear panel.

Pull out control knob. If it is stuck, wrap a small rag around the back of it and pull the rag steadily.

Carefully match marked terminals on the replacement switch with those on original. Switch terminals may not be in the sa... read more

Right front burner would over-heat

  • Customer: Melvin from Attica MI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 12 of 15 people found this instruction helpful
First of all I removed the top panel then removed the switch. I then took pictures of the switch & drew a sketch with all the info. Then I went to your web site, matched up the switch & ordered.
When the switch arrived I went thru the above replacing the bad switch. read more

The left front burner would not turn off, and the switch was sparking

  • Customer: Dan from Mulvane KS
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 6 of 8 people found this instruction helpful
First I unplugged the stove, and removed the upper-back panel. Then I pulled off the control knob. Then I removed the two screws holding the switch to the stove. Then one-by-one I removed the wires from the old switch and connected them to the corresponding tabs on the new switch. Then, using the knob adapter supplied with the new switch, I figured out h... read more