Models > FEC30C4ACD

FEC30C4ACD Frigidaire Cooktop - Overview

Get Parts and Repair Help for FEC30C4ACD

If you know the cooktop repair part you need, you can browse the list of all parts on the FEC30C4ACD, or you can search by name or part description. You can also find your part by where it is located on the FEC30C4ACD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FEC30C4ACD [Viewing 4 of 4]

$3.51

Drip Bowl - 8"

$3.51

Chrome Drip Bowl - 6"

Sold individually.

$28.86

Burner Knob

Sold individually.

$33.18

Surface Burner Switch

$92.11

Surface Burner Coil Element - 8" - 2100W

$4.52

LENS

$31.05

SUPPORT

$7.04

SCREW

$31.48

SWITCH

$29.18

Indicator Light

Common Symptoms of the FEC30C4ACD [Viewing 1 of 46]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner would consistantly go to high no matter where the dial was positioned.

  • Customer: Gary from Herrick IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 9 of 9 people found this instruction helpful
First I unplugged the stove.Removed the upper control panel back (10 phillips screws). Removed the plastic dial( pulls straight off). Removed the 2 screws behind the dial that is holding the switch in the control panel. Took one wire at a time off the old switch and put them on the new switch according to each electrical spade marking. L1, L2, H1, H2 and P.... read more

One of the switches on my stove had quit exept for High. every level on the switch was high.

  • Customer: Marilyn from Lafayette GA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
First I removed the 2 screws that held it in place.
Then I took te screws out of the backguard cover and pulled it down so that I would get to it. Then I unplugged the wires, and replugged them on the new switch, then screwed it back in to the range, then put all the screws back in backguard cover, and plugged the range back up and put it back in its pl... read more

PITTED, ERODED DRIP PANS

  • Customer: Josephine from Malden MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 1 people found this instruction helpful
1. FIRST I PULLED OUT THE HEATING ELEMENT FROM STOVETOP AND REMOVED OLD PAN (NO SCREWS) VERY SIMPLE.

2. PUT NEW PAN IN AND INSERTED THE HEATING ELEMENT BACK IN PLACE. read more