Models > FDB635RBQ1

FDB635RBQ1 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for FDB635RBQ1

If you know the dishwasher repair part you need, you can browse the list of all parts on the FDB635RBQ1, or you can search by name or part description. You can also find your part by where it is located on the FDB635RBQ1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for FDB635RBQ1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Tub Gasket - Gray

The gasket provides a waterproof seal between the tub and the door.


Bottom Gasket

This gasket goes on the bottom of the dishwasher door. Note: Once the gasket is replaced and you continue to have water around the bottom corners of the door panel, you may need to order the splash shield kit.


Lower Dishrack Assembly

This dishrack includes the wheels.


Water Inlet Valve - 120V 60Hz

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.


Upper Dishrack with Wheels


Lower Spray Arm with Shield

This spray arm is located on the lower half of your dishwasher. Water is forced through this spray arm by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and detergent onto the dishes on the dishrack.


Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.



The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage. Size: 7.5 feet long


Lower Rack Roller with Axle

Sold individually.


Dishrack Roller

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water leaking from Inlet Valve

  • Customer: CHRIS from ROANOKE VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 503 of 509 people found this instruction helpful
Remove the bottom cover plate. Disconnect the water inlet and black rubber hose. Remove 2 mounting screws. Pull out electrical connector. Reverse order. Be sure to get the brass inlet connector really tight so it won't leak. I did the final tightning after the part is mounted. Not a bad repair at all. The only problem was that it leaked in the first ... read more

Lower Rack Roller missing

  • Customer: Sandra from Mount Vernon WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 362 of 364 people found this instruction helpful
Took the roller out of the package, snapped it into place. Less than 15 seconds. Works good as new. read more

Bottom Door Seal fell apart and started leaking.

  • Customer: Scott from Flowood MS
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 137 of 148 people found this instruction helpful
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic groove under the doo... read more