Models > FDB1980RGB2

FDB1980RGB2 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for FDB1980RGB2

If you know the dishwasher repair part you need, you can browse the list of all parts on the FDB1980RGB2, or you can search by name or part description. You can also find your part by where it is located on the FDB1980RGB2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for FDB1980RGB2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$10.61

Tub Gasket

The gasket provides a waterproof seal between the tub and the door.

$13.24

Bottom Gasket

This gasket goes on the bottom of the dishwasher door. Note: Once the gasket is replaced and you continue to have water around the bottom corners of the door panel, you may need to order the splash shield kit.

$42.39

Lower Rack with Wheels

$6.53

Single Rack Roller Kit

This kit comes with one axel/clip and one wheel/roller.

$22.55

Water Inlet Valve - 120V 60Hz

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the d...

$37.85

Upper Dishrack with Wheels

$22.96

Lower Spray Arm with Shields

$3.27

Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.

$4.95

ROLLER TUB GREY

$43.18

Drain Pump

The pump ejects the water from the unit.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water leaking from Inlet Valve

  • Customer: CHRIS from ROANOKE VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 467 of 470 people found this instruction helpful
Remove the bottom cover plate. Disconnect the water inlet and black rubber hose. Remove 2 mounting screws. Pull out electrical connector. Reverse order. Be sure to get the brass inlet connector really tight so it won't leak. I did the final tightning after the part is mounted. Not a bad repair at all. The only problem was that it leaked in the first ... read more

Lower Rack Roller missing

  • Customer: Sandra from Mount Vernon WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 362 of 364 people found this instruction helpful
Took the roller out of the package, snapped it into place. Less than 15 seconds. Works good as new. read more

Leak in the water inlet valve/solinoid

  • Customer: Mickey from Ooltewah TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 111 of 120 people found this instruction helpful
1. Shut off water supply.
2. Removed inlet water hose where it connects to the vavle assembly.
3. Removed the two bracket screws holding the assembly to the frame, and detached the electrical connection from the solinoid.
4. Removed the inlet hose adapter connection from old valve and installed into new valve.
5. Attached electrical con... read more