Models > FDB1502RGM4

FDB1502RGM4 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for FDB1502RGM4

If you know the dishwasher repair part you need, you can browse the list of all parts on the FDB1502RGM4, or you can search by name or part description. You can also find your part by where it is located on the FDB1502RGM4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for FDB1502RGM4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$11.18

Upper Spray Arm

This part is located on the top of the tub.

$12.98

Bottom Gasket

This gasket goes on the bottom of the dishwasher door. Note: Once the gasket is replaced and you continue to have water around the bottom corners of the door panel, you may need to order the splash shield kit.

$10.40

Tub Gasket - Gray

The gasket provides a waterproof seal between the tub and the door.

$41.56

Lower Dishrack Assembly

Wheels ARE included.

$6.14

Single Rack Roller Kit

This kit comes with one axel/clip and one wheel/roller.

$22.55

Water Inlet Valve - 120V 60Hz

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

$22.51

Lower Spray Arm with Shields

Water is supplied to this part via the pump assembly.

$3.27

Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.

$4.95

ROLLER TUB GREY

$25.21

Silverware Basket

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water leaking from Inlet Valve

  • Customer: CHRIS from ROANOKE VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 468 of 471 people found this instruction helpful
Remove the bottom cover plate. Disconnect the water inlet and black rubber hose. Remove 2 mounting screws. Pull out electrical connector. Reverse order. Be sure to get the brass inlet connector really tight so it won't leak. I did the final tightning after the part is mounted. Not a bad repair at all. The only problem was that it leaked in the first ... read more

The spray arm would fall off during the washing cycle.

  • Customer: Roy from Worcester MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 446 of 450 people found this instruction helpful
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having the problem that the a... read more

Lower Rack Roller missing

  • Customer: Sandra from Mount Vernon WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 362 of 364 people found this instruction helpful
Took the roller out of the package, snapped it into place. Less than 15 seconds. Works good as new. read more