Models > FDB1250REQ0

FDB1250REQ0 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for FDB1250REQ0

If you know the dishwasher repair part you need, you can browse the list of all parts on the FDB1250REQ0, or you can search by name or part description. You can also find your part by where it is located on the FDB1250REQ0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for FDB1250REQ0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$41.56

Lower Rack with Wheels

$12.98

Bottom Gasket

This gasket goes on the bottom of the dishwasher door. Note: Once the gasket is replaced and you continue to have water around the bottom corners of the door panel, you may need to order the splash shield kit.

$10.40

Tub Gasket

The gasket provides a waterproof seal between the tub and the door.

$22.55

Water Inlet Valve - 120V 60Hz

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

$4.95

ROLLER TUB GREY

$22.51

Lower Spray Arm with Shields

$3.27

Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.

$25.21

Silverware Basket

$43.18

Drain Pump

The pump ejects the water from the unit.

$16.66

Door Spring

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Leak in the water inlet valve/solinoid

  • Customer: Mickey from Ooltewah TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 111 of 120 people found this instruction helpful
1. Shut off water supply.
2. Removed inlet water hose where it connects to the vavle assembly.
3. Removed the two bracket screws holding the assembly to the frame, and detached the electrical connection from the solinoid.
4. Removed the inlet hose adapter connection from old valve and installed into new valve.
5. Attached electrical con... read more

Bottom Door Seal fell apart and started leaking.

  • Customer: Scott from Flowood MS
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 70 of 80 people found this instruction helpful
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic groove under the doo... read more

dishwasher was leaking water

  • Customer: Charles from Milton FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 51 of 63 people found this instruction helpful
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in. read more