Models > FCM7WNBWH

FCM7WNBWH General Electric Freezer - Overview

Get Parts and Repair Help for FCM7WNBWH

If you know the freezer repair part you need, you can browse the list of all parts on the FCM7WNBWH, or you can search by name or part description. You can also find your part by where it is located on the FCM7WNBWH by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for FCM7WNBWH parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FCM7WNBWH [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.09

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$7.95

Compressor Relay

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

$12.37

Power Cord

$17.73

BASKET

$5.77

KEYS

Sold as a pair.

COLD CONTROL

$10.46

HINGE

$17.73

LOCK ASS'Y

$3.62

LOCK COVER ASS'Y

$2.14

DIAL-C0LD CONTROL

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

FREEZER & FRIG WERE NOT COLD

  • Customer: Sam from Cooper City AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 25 of 42 people found this instruction helpful
First I removed the rear cover, located at the bottom of the refrigerator. Then I cleaned out the dirt & dust on and around the compressor. The relay has a cover, that is secured with a spring loaded clip. To release the clip, push in with your fingers, while disengaging the end clip with a screwdriver. Once one side is off the other lifts off. Remove c... read more

Freezer ran constantly

  • Customer: scott from Painesville OH
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 1 of 2 people found this instruction helpful
removed 2 phillips screws for side panel and one for cold control faceplate. Pulled control away from chassis, disconnected wires with pliers, pulled out long sensor wire going into freezer. Installed new part in reverse order. Works like a charm, should save energy and money. read more

compressor running and hot, refer and fridge room temp.

  • Customer: Charles from Durham CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Watched a youtube on capacitors- though on a motor with a pulley, the symptoms were the same, motor running and pulley not turning-bad capacitor. Took a chance for a 17+ dollar part vs a new compressor. It worked. read more