Models > FCM7DSBWH > Instructions

FCM7DSBWH General Electric Freezer - Instructions

All installation instructions for FCM7DSBWH parts

These instructions have been submitted by other PartSelect customers and can help guide you through the freezer repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the FCM7DSBWH
1-4 of 4
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

compressor not starting

  • Customer: H.K. from Seagoville TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 8 of 11 people found this instruction helpful
Refrigerator is not cooling. Light and fan working. Changed the capacitor.. Still not cooling. Back to discovery mode.It may be the timer
Certainly not PartSelect's fault. They have great service.

Frezer door was accendently slamed breaking upper lock cover.

  • Customer: Terry DePaul from yucaipa CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
This was easy, just needed to match the part and order. This is a snap on plastic part and installer needs to examine how to position lock cover before hand. Otherwise the lock covers snap clip(s)will break.

A power surge made my side by side refrigerator stop working

  • Customer: Country at from SAYRE OK
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
I started at the compressor and replaced the overload and the Ptcr first and that did not make the compressor start running again, so I replaced the capasitor and it still did not start, so I bit the bulett and replaced the Main Control Board and that is what I should have checked first, when I removed the old one I found a little burnt spot on the back that I could not see from the front. The new one did not look exactly like the old one, it had two more wire terminals than the old one, but just leave them blank and everything will work just fine!

Compressor not coming on

  • Customer: Kevin from Morris IL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
Had to e-mail GE for electrical schematic. Checked voltages to compressor. Jumpered compressor to see if it would even come on. Found bad run capacitor. Fixed.
All Instructions for the FCM7DSBWH
1-4 of 4